Q.
What is purging of oxygen in thermal power plant
Asked by ANIL KUMAR YADAV,
29 Jan '12 10:50 am
Earn 10 points for answering
Answers (4)
1.
Purging is done to clean furnace from combustible gases by running ID Fan and FD Fan at atleast 30% load for 5 minutes to avoid furnace explosion.
Furnace explosion may be checked by timely purging and adjusting firing properly using right quantity of primary and secondary air and timely oil support and avoiding leakage of fuel oil in boiler. Furnace must be purged properly again if flame is not established during lightup of boiler.
Answered by LIPSIKA, 29 Jan '12 10:57 am
Furnace explosion may be checked by timely purging and adjusting firing properly using right quantity of primary and secondary air and timely oil support and avoiding leakage of fuel oil in boiler. Furnace must be purged properly again if flame is not established during lightup of boiler.
Report abuse
Useful
(1)
Not Useful
(0)
Your vote on this answer has already been received
2.
Expelling oxygen from boiler furnace during light up of Boiler. It is very Important in safety of furnace concerned
Source: rtd engr
Answered by srinivasan, 21 Oct '12 12:29 pm
Report abuse
Useful
(0)
Not Useful
(0)
Your vote on this answer has already been received
3.
Cleaning turbines with oxygen,high pressure oxygen pumped and circulated all innerside of turbines after cleaning removing oxygen plus all impurities
Answered by HEERA, 29 Jan '12 11:12 am
Report abuse
Useful
(0)
Not Useful
(0)
Your vote on this answer has already been received
4.
Report abuse
Useful
(0)
Not Useful
(0)
Your vote on this answer has already been received